Digital printing equipment EP3200 print head

EP3200 print head

a.Digital t-shirt printing machineThe sprinklers are mainly designed in all stainless steel, with super durability, and each sprinkler has 510 pipes.

b. The voltage of the print head can change with the temperature, so that the print head will not be annoyed by the temperature and external factors caused by ink break.

C. The data port of the nozzle can adapt to different printing software, and the printing density is higher than that of the previous nozzle.

d. It can be produced in a variety of modes, the ink dot particles are 35PL and 12PL, the highest standard precision is 720DPI and 1440DPI, and the color saturation is indispensable. The print width of the print head is 75mm, which is 4 times that of ordinary print heads, and can output quickly.

f. It has a wide range of applications and has been used in industrial and commercial printing.

Digital t-shirt printing machinePrecautions for nozzle use

1. Do not install or disassemble the circuit of the digital printing machine at will without turning off the power switch and cutting off the main power supply, or it will damage the service life of each system and endanger the print head.

2. Do not use brute force whether to change or fine-tune the nozzle during use, and replace or fine-tune the nozzle according to the instrument manual.

3. Do not mix the two inks with different configurations during use. Different inks will have different ratios of materials. The use of two different inks will change the color and quality of the ink. Inks with poor quality will directly affect the printing effect. And cause clogging of the nozzle.

4. Do not remove the nozzle from the printer and place it alone, especially in dusty places. The water contained in the ink will gradually evaporate, and drying the ink will cause the nozzle to block. If nozzle clogging occurs, it should be cleaned before use.

5.Garment printing machine nozzleThe cleaning fluid is corrosive to a certain extent, so in the process of using the cleaning fluid to clean the nozzle, take an appropriate amount of capacity and introduce it into the nozzle for cleaning.